Remote Control Code Finder

GDI Technology remote controls can operate audio and video devices of almost any brand. For each of your audio/video devices, you have to enter a Device Code in the remote control. This search tool can help you find the right Device Code for your equipment. Note: Your remote model number is listed inside the battery compartment and or on the front of the remote.

Enter your device information

Your remote:

Device type:

Device brand:

SETUP (MANUAL CODE PROGRAMMING)

	1. Search for the device code in the GDI Code Finder.
	2. Press the DEVICE key for over 3 seconds until the LED lights up.
	3. Input the 3 digit number from the code list, the LED will flash one time if you entered the correct code. Ex:"000". (Inputting the code correctly, the LED will light up.)
	4. Then press the “OK” key , The LED light will switch off after it flashes 2 times and correct code is saved into memory.If the wrong Code is inputted, the LED will light will turn off & light up again to indicate correct code has to be inputed.
	Note: if no keys are pressed for 20 seconds, the LED will turn off and phone will exit Programming Mode.